The child nodes in your Linksys Velop system will usually not have any cables attached to them except the power adapters. To finish the reset, you must perform the same process as you did on your parent node, but with all the child notes in your system. Step #3 Reset All Child NodesĪfter resetting your parent node, now all child notes are idle since they have been disconnected from the network. Release the button once the LED on your parent node starts slowly flashing.Īfter releasing the factory reset button, place your device in the correct position and wait for it to restart.Īfter the restart has concluded, all child nodes will be disconnected from the parent node.Press the factory reset button and hold it down for 30 seconds.Locate the factory reset button in the bottom panel of the device.Double-check that your parent node is in purple or blue light.You will know which node is the parent one if it is connected with your network modem via an Ethernet cable.įollow these steps to reset the parent node in your Linksys Velop system: The parent node can be distinguished from the child notes due to its physical connection with the modem. In order to reset the whole system, you must first initiate the factory reset by resetting your parent node. The parent node is usually a single device and all child nodes will be connected and controlled remotely from the parent node. Step #2 Reset The Parent NodeĪs you probably know already, in your Linksys Velop system, there is a parent node and child nodes. Your nodes must have been actively running for a couple of minutes in order for the reset to work.īefore interacting with any of the nodes, double-check that the LED is either in purple or blue light.Īny other light might indicate an ongoing process and the factory reset button will not work. If you’ve recently restarted or power cycled any of the nodes in your Linksys Velop system, the reset won’t work for a couple of minutes afterward. Such are WiFi names, passwords, security types, and all temporal configurations made will be deleted. Resetting your Linksys Velop will erase all settings and configurations made to your system. Now let’s see how to reset Linksys Velop: Step #1 Prepare Your Devices You will know that your nodes are active if their LED boots up showing a purple or a blue light. Important: Before moving on to the upcoming steps on how to factory reset your Linksys Velop, note that your device must be actively running. Note: Child notes can either be reset as well or reconnected once the parent node has finished the reset. Keep in mind that once the parent node in your Velop system is reset, all child nodes will automatically be disconnected. The only thing you should do is perform the reset on all of the devices within the Velop system. Resetting your Linksys Velop system is pretty easy. Now, let’s review more closely how to reset your Linksys Velop in a step-by-step tutorial. Once done, perform the same action to all child nodes in the household of your Linksys Velop system. To reset your Linksys Velop, locate the parent node and hold down the reset button at the bottom of the device for 30 seconds. ![]() ![]() Wondering how to reset Linksys Velop? Search no further, because you’ve just come across the ultimate guide.īy the end of this post, you will know how to reset your Linksys Velop easily with parent nodes as well as all child nodes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |